Genie 3062m3064 User Manual

13

 Press the PROGRAM/SET button on the powerhead and hold for 

two seconds or until the round LED turns blue.

Steady Blue

Release the PROGRAM/SET button—round LED goes off and the

long LED flashes purple.

Flashing Purple

 Press and hold the UP (+) and DOWN (–) button at the same 

time, until both LEDs flash blue and go off.

Flashing Blue

NOTE: Clearing memory of remotes from the powerhead will clear ALL 

device. 
All remaining (or recovered) remotes and wireless keypads MUST be 

reprogrammed as shown in pages 9,10,12.

 To verify that the memory is cleared, press the remote key that 

was previously programmed to the opener. 

  If the memory has been cleared the opener will NOT run.

If the remote is successfully cleared, the round powerhead LED will 

flash blue when the remote button is pressed and the opener will not 

operate.

NOTE: The garage door opener will operate normally using the wall