Grizzly H3236 Leaflet

MODEL H3236

SLOW SPEED KIT

For G4176

INSTRUCTIONS

4. Remove the chain cover and the two 14mm

hex nuts securing the

Position A & B change

gears to the shafts.

5. Swap the required gears in Positions A & B

shown in

Figure 2.

6. Reinstall the hex nuts and the chain cover.

The Model G4176 power feeder is equipped with
two sets of change gears that provide four different
feed rates of 20, 26, 33, and 43 feet per minute.
The Model H3236 Slow Speed Kit provides
two additional feed rates of 13 and 62 feet per
minute. Use the table below (

Figure 1) and these

instructions to install the required change gears to
get your desired feed rate.

Always disconnect power

to the machine before

performing maintenance.

Failure to do this may

result in serious person-

al injury.

Figure 2. Change gear locations.

Change Gear

Position A

Change Gear

Position B

Change Gear

Chart

To change your power feeder feed rate:

1. Move the switch to the OFF position.

2. DISCONNECT THE POWER FEEDER

FROM POWER!

3. Refer to the change gear table on the inside

of the chain cover (

Figure 2) or the table

Figure 1 to find the gear combination

required for your chosen feed rate.

If you need help with your new item, call our Tech
Support at: (570) 546-9663.

WARNING: NO PORTION OF THESE INSTRUCTIONS MAy BE REPRODUCED IN ANy SHAPE

OR FORM WITHOUT THE WRITTEN APPROvAL OF GRIzzLy INDUSTRIAL, INC.

#CR10849 PRINTED IN TaIWaN

Model H3236 Slow Speed Kit Gears:

A, 16 Tooth + B, 34 Tooth = 13 Ft (4M)/
Per Min

A, 34 Tooth + B, 16 Tooth = 62 Ft (19M)/
Per Min

Original Equipment Change Gears:

A, 20 Tooth + B, 30 Tooth = 20 Ft (6M)/
Per Min

A, 30 Tooth + B, 20 Tooth = 43 Ft (13M)/
Per Min

Original Equipment accessory Change Gears:

A, 24 Tooth + B, 26 Tooth = 26 Ft (8M)/
Per Min

A, 26 Tooth + B, 24 Tooth = 33 Ft (10M)/
Per Min

Change Gear and Feed Rate Chart

Figure 1. Change gear table.