Grizzly G4173 1 8 HP User Manual
-16-
Model g4173
1
⁄
8
hp power Feeder
position the power feeder on the table top to
determine where to drill your base mounting
holes, so you can maximize power feeder swing
and adjustment options.
determine where to drill your base mounting
holes, so you can maximize power feeder swing
and adjustment options.
there are thee mounting options available:
Through Bolt Mounting, Direct Mounting, and
Quick Holder Kit Mounting (discussed on Page
17). Choose an option that suits your require-
ments.
ments.
Whichever way you mount your power feeder,
you must be able to use the handwheels and lock
levers to position the rubber wheels parallel with
the table surface and
you must be able to use the handwheels and lock
levers to position the rubber wheels parallel with
the table surface and
1
⁄
8
"
lower than the thickness
of your workpiece.
also, you must be able to point the power feeder
slightly towards the machine fence (
slightly towards the machine fence (
Figure 15). in
other words, the tracking of the power feeder must
be toed-in approximately 1° to 1.5° degrees toward
the machine fence so the rubber wheels slightly
push the workpiece against the fence during cut-
ting operations.
be toed-in approximately 1° to 1.5° degrees toward
the machine fence so the rubber wheels slightly
push the workpiece against the fence during cut-
ting operations.
;ZZY
;ZZY
Tablesaw
Shaper
8jiiZg
;ZZY
Jointer
8jiiZg]ZVY
7aVYZ
;ZcXZ
;ZcXZ
;ZcXZ
)i]"GdaaZg
BdYZah
Figure 15. typical power feed mounting on a shaper, jointer, and tablesaw.
base Mounting