Tascam DM-3200 User Manual
7 – MIDI : Program Change messages and the DM-3200
92
TASCAM DM-3200
User’s Manual
Program Change messages and the DM-3200
The DM-3200 can receive Program Change mes-
sages to recall snapshot settings, or settings from
either of the two effect libraries.
sages to recall snapshot settings, or settings from
either of the two effect libraries.
1
Use the
MIDI
key to bring up the
PROG. CHANGE
2
Use the POD 3 encoder to choose which
library item to select (
library item to select (
SNAPSHOT
,
EFFECT1
, or
EFFECT2
).
3
The screen shows 32 programs at a time. Use
the POD 4 encoder to select which group of 32
programs will be shown.
the POD 4 encoder to select which group of 32
programs will be shown.
4
Use the cursor keys and wheel to select and set
incoming program change numbers (
incoming program change numbers (
PROG No.
),
—
0
through
127
; the bank (
LIBRARY BANK
) —
P1
for preset,
B1
through
B4
for the user CF card
banks; and the number in the library (
LIBRARY
No.
) 000 through 127.
NOTE
The effect libraries have two preset banks - these are
labeled as P1 and P2 here.
labeled as P1 and P2 here.
Setting the MIDI channels
To allow the pro-
gram changes to be made independently for the three
types of library recall, select different MIDI channels
for the snapshot and effect libraries using the
types of library recall, select different MIDI channels
for the snapshot and effect libraries using the
MIDI CH
SETUP
block at the top left of the screen.
Batch setup
In order to assign a group of contigu-
ous program change values to a contiguous group of
library entries in the same bank, use the
library entries in the same bank, use the
BATCH SET UP
block at the lower left of the screen.
•
Select the starting and ending incoming Pro-
gram Change numbers (
gram Change numbers (
PROG No.
). You must
press
ENTER
to confirm these values.
•
Select the library bank (
P1
or
B1
through
B4
)
for the batch process.
•
Select the starting Library slot number
(
(
LIBRARY No.
). The highest library slot number
is automatically determined from the Pro-
gram Change values set earlier.
gram Change values set earlier.
•
When all values have been set, move the cur-
sor to the on-screen
sor to the on-screen
SET
button and press
ENTER
.
NOTE
Program Change messages are sent and received
through USB MIDI port 4. Enable this port in the MIDI
SETUP screen (“MIDI port switching and filtering” on
page 91) or the MIDI input and filter switches for the
physical MIDI ports.
through USB MIDI port 4. Enable this port in the MIDI
SETUP screen (“MIDI port switching and filtering” on
page 91) or the MIDI input and filter switches for the
physical MIDI ports.
MIDI Implementation Charts
These are available as downloads from the TASCAM
Web site.
Web site.
Figure 7.2: MIDI Program Change screen