Panasonic WV-NP472 User Manual

-22-

1. Move the cursor to CAMERA RESET. PUSH SW is

highlighted.

2. While holding down 

L and  M, hold down I

for 2 seconds or more. The camera is reset to the
factory settings.

Set up network parameters when connecting the
10/100BASE jack with a network.

• Access the setup menu from the PC to use the

DHCP or DNS server, because these settings are
not included in this window.

• Ask your system administrator or ISP (Internet

Service Provider) about available IP address, sub-
net mask, and gateway, prior to setup.

• The assigned address should be a global type

when connecting via the Internet. Ask your ISP
whether it is.

1. Move the cursor to NETWORK SETUP in the SETUP

menu window and press 

I. The NETWORK

SETUP menu opens. 

The factory default settings are as follows.

192.168.0.10

255.255.255.0

192.168.0.1

80

2. Move the cursor to the line you wish to edit, and

press 

I.

Parameters become editable.

3. Select a digit using 

J or K. 

4. Select a number in the digit using 

L or M.

5. Repeat steps 2, 3 and 4 above appropriately until

all parameters are set.

6. Move the cursor to END and press 

I to close the

setup menu and store new settings, or select RET
to go back to the SETUP menu.

The port number assigned to the camera is

exclusive, and any other usage is not allowed.