Fisher & Paykel V3 DD603 User Manual

Page of 12
R
INSTALLATION INSTRUCTIONS
 
Be sure product is level, securely fastened to the cabinetry and 
 
opens and closes freely.  The DishDrawer® must be free to close 
 
with no resistance from the cabinetry.
 
Be sure the inlet hose to valve connection is tightened a further half 
 
turn after seal contact.
 
Be sure any knock-outs or plugs in drain connection have been 
 
drilled out and drain connection has been made.
 
Turn ON the power and water supply.  The DishDrawer® should 
 
beep and light up.
 
Open the drawer(s) and check operation of Wash Program Control 
 
Panel and check the sprayarm(s) are in place and free to rotate.
 
On the Wash Program Control Panel select Rinse and close the 
 
drawer(s).  Start the program by pressing the Start/Pause button.
 
After the Rinse program has finished, be sure the machine has run 
 
and drained correctly.
 
Check water supply and drainage connection for leakage.
 
Repeat for each Drawer.
 
LEAVE ALL LITERATURE WITH CUSTOMER.
TROUBLE SHOOTING
 
Excessive water remaining above the filter plate, after the 
 
rinse cycle; check for kinked drain hoses or blocked waste 
 connection.
 
No water supply; check water is connected, ON and there is 
 
the specified water pressure.
 
DishDrawer® does not light up when the tub is opened; 
 
be sure power is connected and is switched ON.
 
Water around water supply and drainage connections - 
 
check connections, existing plumbing and hoses for leaks.
 
If a fault occurs, consult the Fault Code Section of the 
 User 
Guide.
 
If unable to resolve, contact your Customer Care Centre.
If you have any questions concerning the installation of this DishDrawer®, 
please contact your Fisher & Paykel Authorized Service Agent.
FOR THE UNITED STATES OF AMERICA (USA) & CANADA
Fisher & Paykel Appliances
5900 Skylab Road
Huntington Beach
CA 92647
PHONE TOLL FREE 
1888 9 FNP USA
 
 
 
1888 9 367 872
w w w. u s a . f i s h e r p a y ke l . c o m
STEP 11:
  FITTING THE TOE KICK TO THE PRODUCT 
(DOUBLE MODELS ONLY)
STEP 13:
  CUSTOMER CARE
12
Important!
DO NOT over tighten screws.  
Overtightening will damage the plastic mounting detail.
  Partly open bottom drawer. Position Toe Kick behind door and slide 
 onto the mounting rails on the underside of tub.
 Close bottom drawer, check if flush with adjacent cabinetry.  
 If required open drawer and adjust.
 
Note: Clearance between Toe Kick and floor must be 
 
15
/
32
” (12mm) minimum.
 
When Toe Kick is in position, open bottom drawer and gently fasten 
 
the Toe Kick screws, on each side.
STEP 12:
  FINAL CHECKLIST 
(DOUBLE AND 
SINGLE MODELS
)
25
25
26
26
Toe kick 
mounting rails