Frigidaire 4400 Series User Manual

11

 

 

 

 

 

water spots and filming. Water "sheets" off 

dishes rather than forming water droplets that cling 

and leave spots. 

A dispenser, located next to the detergent cup, 

automatically releases a measured amount of 

rinse aid during the last rinse. If spotting and poor 

drying are problems, increase the amount of rinse 

aid dispensed by rotating the dial to a higher 

number. The dial is located under the dispenser 

cap. The indicator will be dark when full and will 

show clear when it is time to refill. 

To add liquid rinse aid, turn dispenser cap 1/4 turn 

counterclockwise and lift out. Pour in rinse aid until 

liquid touches the indicated fill level. Replace cap.

 

Do not overfill since this can cause over-sudsing. 

Wipe up any spills with a damp cloth.

The dispenser holds enough for 35 to 140 washes, 

depending on setting.

The hot water line to dishwasher must provide 

water pressure between 20 and 120 psi. 
Low water pressure may occur when laundry or 

showers are in operation. Wait until water use is 

reduced before starting dishwasher.

Hot water is needed for best dishwashing and 

drying results. Water entering dishwasher should 

be at least 120° F (49° C) to give satisfactory 

results.  

 

To check water temperature entering dishwasher:

•  Turn on hot water faucet nearest dishwasher for 

several minutes to clear cool water from pipes. 

•  Hold a candy or meat thermometer in stream of 

water to check the temperature. 

•  If temperature is below 120° F (49° C), have 

a qualified person raise the hot water heater 

thermostat setting.