Indesit DIF04 User Manual

EN

3

Connecting the water outlet hose

Connect the outlet hose (without bending it) to a drain duct
with a minimum diameter of 4 cm. Alternatively, rest it over a
sink or tub; the free end of the hose should not remain
immersed in water.

The special plastic elbow*
makes it easier to find the
best layout: fix the elbow to
the wall securely in order to
prevent the outlet hose from
moving and spilling the dirty
water.
The part of the hose marked
with the letter A should be
between 40 and 100 cm
above the ground (

see

figure).

We advise against the use of hose extensions.

Electrical  connection

Before inserting the plug into the electrical socket, make sure
that:

• The socket is earthed and complies with current

regulations.

• The socket can withstand the maximum load of the

appliance, which is indicated on the data plate located on
the inside of the door (

see chapter entitled Description of

the appliance).

• The power supply voltage falls within the values indicated

on the data plate on the inside of the door.

• The socket is compatible with the plug of the appliance. If

this is not the case, ask an authorised technician to replace
the plug (

see Assistance); do not use extension cables or

multiple sockets.

Once the appliance has been installed, the power supply

cable and the electrical socket should be easily accessible.

The cable should not be bent or compressed.

 If the power supply cable is damaged, it must be replaced

by the manufacturer or its Technical Assistance Service in order
to prevent all potential hazards. (See Assistance)

The Company shall not be held responsible for any

incidents that occur if these regulations are not observed.

Anti-condensation  strip*

After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order to

protect it from any condensation which may form.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add only then approximately 1 kg of salt (

see

chapter entitled Rinse aid and refined salt). The water may
overflow: this is normal and is not a cause for concern. Select
the water hardness value (

see chapter entitled Rinse aid and

refined salt).  

- After the salt has been poured into the

machine, the LOW SALT indicator light* switches off.

 If the salt container is not filled, the water softener and the

heating element may be damaged as a result.

* Only available in selected models.

Technical  data

width 59.5 cm 
height 82 cm 
depth 57 cm

 

12 standard place-settings 

0,05 ÷ 1MPa (0.5 ÷ 10 bar) 
4.3 psi – 145 psi 

See appliance data plate 

See appliance data plate 

See appliance data plate 

 

This dishwasher conforms to 
the following European 
Community Directives:  
-73/23/EEC dated 19/02/73 
 (Low Voltage) and 
subsequent modifications 
-89/336/EEC dated 03/05/89 
(Electromagnetic 
Compatibility)  
and subsequent modifications 
-97/17/EC (Labelling) 
-2002/96/ CE (

Waste 

Electrical and Electronic 
Equipment WEEE)