Bosch 119 User Manual
ENGLISH - 15
ENGLISHENGLISHENGLISHENGLISHENGLISH
www.boschappliances.com
SHU 6800 Series Base and Toe Panel Installation Steps
BASE AND TOE PANEL
Assembly Steps
•
Place J-Box Cover on J-Box, insert
and tighten screw (Figure 26).
and tighten screw (Figure 26).
•
Drop screws inside holes in base part.
•
Slip Base Part under and up front
bottom panel of dishwasher. Tighten
Base Part Screws - LOW TORQUE,
USE HAND TOOL ONLY.
bottom panel of dishwasher. Tighten
Base Part Screws - LOW TORQUE,
USE HAND TOOL ONLY.
•
Slip Cotton Insulation Strip under
unit, between the bottom of Base
Part and the floor.
unit, between the bottom of Base
Part and the floor.
Installation Parts
•
SHU 6800 Base Part
•
Base Part Screws
•
SHU 6800 Toe Panel
•
SHU Toe Panel Screws
•
SHU 6800 Installation Kit
(Refer to “Materials Supplied” section)
Remember to carefully check, the “Materials
Supplied” section against the SHU6800
Installation Kit bag and contents.
Disassembly Steps
•
Pull Toe Panel off (Figure 25).
•
Remove Base Part by pulling it out
and downward.
and downward.
Junction Box Cover is required
for any installation application
After installation, water and electrical
lines are connected and the unit leveled,
assemble the base part (see below).
Figure 26
Figure 24
Figure 25
SHU6800 BASE PARTS
SHU6800 Base Part
Toe Panel
Base Part
Screws (1lft &1rgt)
(attached)
Junction Box Cover and Screw