Electrolux WT30H240WS User Manual

18

cedure described in the paragraph “Manual activa-
tion” at least 3 times.

• Completely drain the boiler by simultaneously pres-

sing the buttons as shown in the figure.

A buzzer indicates completion of drainage.
• Spread a thin film of petroleum jelly over all the stain-

less steel surfaces.

Preventive maintenance
The preventive maintenance message “CALL” may be 
activated.
Upon reaching the set number of cycles (e.g. 20000), 

 

              appears on the display. 
This message advises calling a qualified authorized ser-
vice technician for a general check-up on of the state of 
the appliance.
NOTICE: CONTACT YOUR AUTHORIZED SERVICE 
COMPANY TO PERFORM MAINTENACE AND 
REPAIRS
NOTICE: Using any parts other than genuine factory 
manufactured parts relieves the manufacturer of all war-
ranty and liability.
NOTICE: Manufacturer reserves the right to change spe-
cifications at any time without notice.
WARNING: The equipment warranty is not valid unless 
the appliance is installed, started and demonstrated 
under the supervision of factory trained installer.
WARNING: The unit must be installed by Personnel who 
are qualified to work with electricity and plumbing. 
Improper installation can cause injury to personnel 
and/or damage to the equipment. The unit must be 
installed in accordance with applicable codes.

These models have a continuous softener in the 
dishwasher water circuit. By means of special resins, 
this device removes the calcareous substances from the 
feed water, supplying decalcified water for washing.
For the continuous softener to work properly the resins 
must be regenerated periodically, with frequency depen-
ding on the hardness of the water and the number of 
wash cycles carried out.
Unlike conventional water softeners, this continuous sof-
tener does not require machine stops for regenerating 
the resins.

Salt container
The water can only be softened if there is salt in the spe-
cial container. The salt container must be filled when the 
dishwasher is used for the first time and whenever the 
message 

SAL

 

0

 is displayed at the start of a wash 

cycle.

No salt in the container
If the message 

SAL

 

0

 is displayed at the start of a 

wash cycle, it means that the salt container is empty. 
Wash cycles can be started just the same, even if the 
display signals no salt; in which case the water used for 
washing is not softened.

How to fill the salt container
• Switch off the dishwasher by pressing button “A” 

• Unscrew cap "A" (Figure 20) of the salt container, tur-

ning it anticlockwise.

1

2

3

150

15

14

200

20

10

250

25

7

300

30

6

350

35

5

400

40

4

The factory setting of max. outlet water hardness is 100 ppm / 10 °fH.

 

SAL  0

SAL 0