Smeg PX140D User Manual

Page of 16
 
 
 
Instructions for the User
 
 
 
32 
 
7.2  Lighting burners with safety device 
 
 
 
 
 
 
 
The burner it controls is shown next to each knob (the example here shows the front 
left-hand burner). 
 
The appliance is equipped with electronic ignition. Simply press the knob and turn it 
anti-clockwise to the minimum flame symbol   , until the burner lights. Keep the knob 
pressed down for about 2 seconds to keep the flame alight and prime the safety 
device. The burner may go out when the knob is released. In this case, repeat the 
operation, keeping the knob pressed down for longer. 
 
When the burner has lit, its control knob will light up to confirm that it is in operation.  
The knob will go out a few seconds after it is turned to the O position, or if the burner 
goes out accidentally. The knob light comes on and goes out gradually. 
 
 
 
 
If the burners should go out accidentally the safety device will be tripped about 20 
seconds later, cutting off the gas supply even if the gas tap is open. 
 
 
7.3  Practical hints for using the burners 
For better burner efficiency and to minimise gas consumption, use flat, 
even -bottomed pans with lids of suitable size for the burner (see point 
"
 
7.5 Pan diameters"). 
 
When cooking, to prevent burns or damage to the hob all pans or griddle 
plates must be placed inside the perimeter of the hob and must be at least 
5-7 cm from the knobs.