Samsung C21RJAN User Manual

Page of 28
5
EN
Installing the Hob
Important: Be sure the new appliance is installed and grounded only by qualified 
personnel 
Please observe this instruction  The warranty will not cover any damage that may 
occur as a result of improper installation 
Technical data is provided at the end of this manual 
Regulations and compliance
This appliance meets the following standards:
•  EN 60 335 - 1 and EN 60 335 - 2 - 6, relating to the safety of electrical appliances for 
household use and similar purposes;
•  EN 60350, or DIN 44546 / 44547 / 44548, relating to the operating features of electric 
cookers, hobs, ovens, and grills for household use;
•  EN 55014 - 2;
•  EN 55014;
•  EN 61000 - 3 - 2; and
•  EN 61000 - 3 - 3, relating to basic requirements for electromagnetic compatibility (EMC) 
This appliance complies with the following EU Directives:
•  73 / 23 / EWG dated 19 02 1973 (Low Voltage Directive);
•  89 / 336 / EWG dated 03 05 1989 (EMC Directive including Amending Directive 
92 / 31 / EWG); and
•  93 / 68 / EWG CE Labeling Directive 
Safety instructions for the installer
•  With respect to fire protection, this appliance corresponds to EN 60 335 - 2 - 6. This type of 
appliance may be installed with a high cupboard or wall on one side 
•  Drawers may not be fitted underneath the hob.
•  The installation must guarantee shock protection 
•  The kitchen unit in which the appliance is fitted must satisfy the stability requirements of 
DIN 68930 
•  For protection against moisture, all cut surfaces are to be sealed with a suitable sealant 
•  On tiled work surfaces, the joints in the area where the hob sits must be completely filled 
with grout 
•  On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in 
place with a suitable artificial resin or mixed adhesive.
•  Ensure that the seal is correctly seated against the work surface without any gaps  
Additional silicon sealant must not be applied; this would make removal more difficult when 
servicing 
•  The hob must be pressed out from below when removed 
•  A board is to be installed underneath the hob 
C21RJAN_XSA-00144A_EN.indd   5
2008-10-07     5:01:13