Jenn-Air 8111P533-60 User Manual

• Remove knobs in the OFF position by

pulling up.

• Wash, rinse and dry. Do not use abrasive

cleaning agents as they may scratch the
finish.

• Turn on each burner to be sure the

knobs have been correctly replaced.

Porcelain enamel is glass fused on metal
and may crack or chip with misuse. It is
acid resistant, not acid proof. All spillovers,
especially acidic or sugary spillovers,
should be wiped up immediately with a dry
cloth.
• When cool, wash with soapy water, rinse

and dry.

• Never wipe off a warm or hot surface

with a damp cloth. This may cause
cracking or chipping.

• Never use oven cleaners, abrasive or

caustic cleaning agents on exterior finish
of range.

• DO NOT USE ANY CLEANING PROD-

• ALWAYS WIPE WITH THE GRAIN

• Daily Cleaning/Light Soil –– Wipe with

one of the following - soapy water, white
vinegar/water solution, Formula 409
Glass and Surface Cleaner* or a similar
glass cleaner - using a sponge or soft
cloth. Rinse and dry. To polish and help
prevent fingerprints, follow with Stainless
Steel Magic Spray (Jenn-Air Model A912,
Part No. 20000008)**.

• Moderate/Heavy Soil –– Wipe with

one of the following - Bon Ami*, Smart
Cleanser*, or Soft Scrub* - using a damp
sponge or soft cloth. Rinse and dry.
Stubborn soils may be removed with a
damp Scotch-Brite* pad; rub evenly with
the grain. Rinse and dry. To restore luster
and remove streaks, follow with Stainless
Steel Magic Spray.

• Be sure appliance is off and all

• To prevent staining or discoloration,

clean appliance after each use.

• If a part is removed, be sure it is

correctly replaced.

Removable Burner Caps
• Allow burner to cool. Remove burner cap

and wash in soapy water with a plastic
scouring pad. For stubborn soils, clean
with a soap-filled, nonabrasive pad or
Cooktop Cleaning Creme (Part
#20000001)** and a sponge.

• Do not clean in dishwasher or self-

cleaning oven.

Sealed Gas Burner
• Clean frequently. Allow burner to cool.

Clean with soap and plastic scouring pad.
For stubborn soils, clean with a soap-
filled, nonabrasive pad.

• Be careful not to get water into the center

of the burner.

• Use care when cleaning the ignitor. If the

ignitor is wet or damaged the surface
burner will not light.

• To ensure even cooking performance,

keep burner ports free of food soils/
debris.

• Wash grates with warm, soapy water and

a nonabrasive, plastic scrubbing pad. For
stubborn soils, clean with a soap-filled,
nonabrasive pad or Cooktop Cleaning
Creme (Part #20000001)** and a sponge.
If soil remains, reapply Cooktop Cleaning
Creme, cover with a damp paper towel
and soak for 30 minutes. Scrub again,
rinse and dry.

• Do not clean in dishwasher or self-

cleaning oven.

* Brand names for cleaning products are registered trademarks of the respective manufacturers.
** To order direct, call 1-800-JENNAIR (1-800-536-6247).

• Check to be sure plug is securely inserted

into receptacle.

• Check or re-set circuit breaker.  Check or

replace fuse.

• Check power supply.
• Check to be sure burner is correctly rated

for your kind of gas.

• Check to be sure burner ports or ignition

ports are not clogged.

• Check to be sure ignitor is dry and

clicking. Burner will not light if ignitor is
damaged, soiled or wet. If ignitor doesn’t
click, turn control knob OFF.

• Check to be sure burner cap is correctly

seated on the burner base.

• Check that the gas is turned on.

• Check to be sure a pan is sitting on the

grate above.

• Contact an authorized Jenn-Air servicer.

• Burner ports may be clogged.
• Flame may need to be adjusted. Contact

an authorized Jenn-Air servicer.

• Contact an authorized Jenn-Air servicer.
• Some yellow tips on the flame are

acceptable when using LP gas.

• Discoloration –– Using a damp sponge or

soft cloth, wipe with Cameo Stainless Steel
Cleaner*. Rinse immediately and dry. To
remove streaks and restore luster, follow
with Stainless Steel Magic Spray.

8111P491-60

5/18/06, 3:07 PM

7