Beko GNE 134620 X User Manual

Page of 32
EN
11
Installing Water Filter 
(in some models)
Two different water sources may 
be connected to the refrigerator for 
water supply: the mains cold water 
supply and water in a bottle.
Installation Requirements
A pump should be used for bottle water 
usage.
Check that the parts stated below are 
supplied with your appliance.
1.  Union for connection of the water 
pipe to the rear of the appliance. (If it 
does not fit, provide it from the nearest 
authorized service.)
2.  2 pieces of pipe clips (In case required 
to secure the water pipe)
Note: Since the following parts are 
not required in use with a bottle, they 
may not be found in the product you 
purchased.
3.  5-meter long water pipe (1/4 inch in 
diameter)
4.  Cold mains water valve with mesh filter 
(Tap Adapter)
5.   Water Filter or externally connectable 
filter to be fitted to the bracket inside 
the fridge compartment.
Place where the external filter is going to 
be fitted should be determined first. 
(Applies to the filter being used outside 
the refrigerator.) Then, determine the 
distance between the filter and the 
refrigerator and required hose lengths 
from the filter to the refrigerator water 
inlet.
Water filter must be hold upright as shown 
in the figure. It is important to properly 
attach the filter to water inlet and water 
outlet points.
After attaching the filter, do not use first 3-4 
glasses of water.
Connection of the Water 
Pipe to the Refrigerator
1. After installing the union onto the 
water pipe, insert the water pipe to 
the refrigerator inlet valve by pressing 
downwards firmly.
2. Fix union as seen in the opposite 
figure, by squeezing by hand on the 
refrigerator inlet valve.
(a- Water Pipe, b-Union, c-Valve)
C
 Note 1: You should not need to 
tighten the union with a tool to achieve 
water tight assembly. In case of a leak 
use a spanner or a pair of pliers to 
tighten the union.
3
1
4
2
5
c
a
a
b
1
2