Beko GNE 134620 X User Manual

EN

13

(in some models)
If you want to use your refrigerator by 
connecting it to the cold water mains 
line, 
you will have to connect a standard 1/2" 
valve connection fitting to the cold water 
supply in your house. In case this valve is 
not present or in case you are not sure, 
consult a qualified plumber.
1.  Separate the union from the tap 

adaptor. (Figure A) 

2.  Install the tap adaptor to 1/2” valve 

fitting as shown in the figure. (Figure B) 

3.  After inserting the water pipe to the 

union, install it to the tap adaptor and 
insert to the tap as shown in the figure.     
(Figure C) 

4.  Tighten the union manually. In case of a 

leak use a spanner or a pair of pliers to 
tighten the union. 

A

 Caution: Secure the water pipe 

to suitable points by means of the 
pipe clips supplied to avoid any 
damage or displacement or accidental 
disconnection.

A

 Caution: After turning on the water 

valve, make sure that there is no leakage 
at both connection points of the water 
pipe. In case of a leak, turn off the valve 
immediately and tighten all joints again 
using a spanner or a pair of pliers.

A

 Caution: Make sure that standard 

1/2" valve fitting fed by cold mains water 
supply is available and is turned off fully. 
To fit the water filter follow the 
instructions below referring to figures 
supplied:
1.  Press ice cancel button on the display.