Grindmaster 5311 User Manual

1) 

Remove the four screws that hold the right side panel on 
the machine.

2) 

Install the filter panel over the existing side panel and
reinstall screws. (See Figure D)

3) 

Open top cover of filter cover by raising and rotating away from
the existing panel.

4)

Slide filter into top of filter cover with removal clip up and 
the air flow arrows facing the existing panel. (See Figure E)

5)

Push filter down until flush with the top of the cover.

6)

Close the top cover by rotating the top back toward the 
existing cover and pushing down once it is in place.

(Part #W089.0206)

1) 

Remove the four panel screws.

2)

Pull the bottom of the panel out.

3)

Run a bead of the silicone adhesive at the inside back of the
bottom filter channel. (2)

4)

Install the channel over the end of the side panel so the adhesive
in the channel contacts the bottom edge of the side panel.

5)

Put the panel with the channel added, back in place on the
machine and reinstall the two lower panel screws.

6)

Apply silicone adhesive to the length of the top edge of the upper
filter channel (1) before installing, then wipe off any excess.

7)

Install the upper channel using the upper panel screws.

8)

Slide filter (3) in from the front with the arrows pointing toward the
existing panel. The thick wire side of the filter should face
outward.

Figure D

Figure E

Figure G

(Part #s W089.0200 Stainless Steel, W089.0208 Black)

INSTALL THE FILTER
PANEL OVER THE
EXISTING SIDE PANEL
& RE-INSTALL SCREWS.

P/N: W0520101, COMES
IN KIT # W0890220
FILTER PANEL

P/N: W0631805

FILTER

SLIDE THE FILTER IN BEHIND THE FILTER PANEL, &
IN FRONT OF THE EXISTING SIDE PANEL.
TO CHANGE REMOVE, CLEAN, & OR REPLACE.