KitchenAid 2300276B User Manual
5
■
Dispose of/recycle all packaging materials.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your beverage center before using it. See the cleaning
instructions in “Beverage Center Care.”
of your beverage center before using it. See the cleaning
instructions in “Beverage Center Care.”
Door Closing
Door Closing
Your beverage center has four leveling legs. If your beverage
center seems unsteady or you want the door to close more
easily, adjust the beverage center’s tilt using the instructions
below.
center seems unsteady or you want the door to close more
easily, adjust the beverage center’s tilt using the instructions
below.
1. Plug into a grounded 3 prong outlet.
2. Move the beverage center into its final location.
3. Turn the leveling legs to the right to lower the beverage center
or turn the leveling legs to the left to raise it. It may take
several turns of the leveling legs to adjust the tilt of the
beverage center.
several turns of the leveling legs to adjust the tilt of the
beverage center.
NOTE: Having someone push against the top of the beverage
center takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
center takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
4. Open the door and check to make sure that it closes as easily
as you like. If not, tilt the beverage center slightly more to the
rear by turning both front leveling screws to the right. It may
take several more turns, and you should turn both leveling
legs the same amount.
rear by turning both front leveling screws to the right. It may
take several more turns, and you should turn both leveling
legs the same amount.
Base Grille
Remove the Base Grille
1. Open the beverage center door.
2. Using a Phillips screwdriver, remove the two screws. Push
both tabs in toward the center to release the base grille from
the beverage center.
the beverage center.
3. Remove the base grille.
Replace the Base Grille
1. Open the beverage center door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.
screws.
When Moving Your Beverage Center:
Your beverage center is heavy. When moving the appliance
for cleaning and service, be sure to protect the floor. Always
pull the appliance straight out when moving it. Do not
wiggle or “walk” the appliance when trying to move it, as
floor damage could occur.
for cleaning and service, be sure to protect the floor. Always
pull the appliance straight out when moving it. Do not
wiggle or “walk” the appliance when trying to move it, as
floor damage could occur.
Important information to know about glass shelves
and covers:
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use special care when
removing them to avoid impact from dropping.
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use special care when
removing them to avoid impact from dropping.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
fire, or electrical shock.
WARNING
A. Tabs
B. Screws
B. Screws
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
beverage center.
Failure to do so can result in back or other injury.
B
A
A