EdgeStar 866-319-5473 Leaflet

Parts List

Installation Guide

Beer Dispenser

866-319-5473

For assistance, please call:

Make sure unit is empty (including white metal keg floor(11)). Carefully 

tip the beer dispenser on its side. Connect the casters(13) to the cabinet 

by screwing in each metal bracket into one of four caster holes (casters 

in the front of the cabinet require the washers(12)). Then carefully set 

the unit upright 

Open the door, and with your hand push the top cabinet plug 

through the top of the cabinet. Use flat head screwdriver as a prying 

tool if necessary. 

Now begin installing the tower(3). Unravel the beer line hose from the 

bottom of the tower, and feed the hex nut and beer line through the hole 

you uncovered in the top of the cabinet.

Once you have fed all the line into the cabinet, you can now place the 

tower into the unit. Align the black plastic adapter on the bottom of the 

tower to the hole in the top of the cabinet. The adapter should mate 

securely with the hole. Then turn the adapter about 25° to lock it into 

place. The faucet connection for the tower should now face the front of the 

cabinet. If the tower is not facing the front of the cabinet, remove it and 

reinstall it from another position. 

Take the railing(4) and slide its 

“feet” into the pilot holes in the 

top of the cabinet

Thank you for purchasing the EdgeStar Beer Dispenser. 

Are you ready to enjoy some draft beer now? 

All you need is:

   • 

Included components (pictured to the left)

   • 

Wrench

   • 

Flat head screwdriver

   • 

Pair of pliers/clamp crimper

   • 

Full keg of beer (1/2 barrel size or smaller [pictured to the left but not included])

Note: Any Coors Brand or Miller Rubber Sided kegs will not fit inside this unit.

   • 

Also, fill the included CO2 tank with CO2 (Most beer keg providers can fill your CO2 tank) 

Notice: this manual is provided as a supplement to the owner’s manual. Please refer to the owner’s 

manual for a full discourse on installation, usage and maintenance. 

Note: Parts listed throughout this installation guide are numbered according to the diagram parts list.

1.  Faucet Handle    

2.  Faucet

3.  Beer Tower

4.  Guard Rail

5.  Drip Tray

6.  Regulator

7.

CO

2

 Tube

8.

CO

2

 Cylinder (supplied empty)

9.  Cylinder Holder

10.  American Sankey Keg Coupler

11.  Metal Keg Floor Support

12.  Caster Washer (x2)

13.  Casters (x4)

14.  Neoprene Washer

15.  Snap-On Clamps (x2)

16.  Wire Shelves (not shown) (x2)

17.  Half Barrel Keg (not included)

18.  Faucet Wrench

Warning: 

CO2 can be dangerous! CO2 cylinders contain high-pressure gas, which can be hazardous if 

handled improperly. Please handle with care.

Note: Included accessories may not be as pictured

Warning:

 This guide is provided for informational purposes only. If you have any questions about 

the installation of this appliance, feel free to contact EdgeStar service at 866.319.5473 or consult 

a qualified installer. Neither the manufacturer nor its distributors shall be liable for any incidental, 

consequential, indirect, special, or punitive damages of any nature, including without limitation, 

lost revenues or profits, or any other damage whether based in contract, tort, or otherwise.