Cisco Systems DOC-7812945= User Manual
B-4
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Appendix B Networking
Configuring Network Management
Figure B-1
In-Band Management - Basic Hub Attachment Without Router
Note
Use valid IP addresses for devices in your network and avoid using upper-case characters in the files.
The addresses provided in the following examples should be replaced with your network’s device
addresses.
The addresses provided in the following examples should be replaced with your network’s device
addresses.
Step 1
Modify the /usr/users/svplus/config/network.conf file to include the name of the Gateway node in the
third field to igx2, and change the last field (IP Reachability Flag) to nwip_off.
third field to igx2, and change the last field (IP Reachability Flag) to nwip_off.
The options for the IP Reachability Flag are:
•
NWIP_OFF—for in-band management
•
NWIP_ON—for out-of-band management
The contents of the network.conf file should look similar to the following:
NETWORK:Network1
GATEWAYS:igx2
DISCOVERY PROTOCOL:AUTOROUTE
IP REACHABILITY FLAG:NWIP_OFF
Step 2
Modify the /etc/hosts file to include (along with the file’s usual contents) the IP addresses and device
names described in Step 3.
names described in Step 3.
Step 3
Modify the /etc/rc2.d/S72inetsvc file to add routes by adding a lines similar to the following:
CWM
workstation
172.70.207.5
Link 0
Link 0
Link 1
Link 1
Link 1
SNMP
TFTP
SNMP
TFTP
IGX2
Gateway node
IP-Lan 172.70.207.6
IP-Relay 192.0.0.6
IGX3
IP-Relay
192.0.0.7
BPX4 IP-Relay
192.0.0.8
IP-Relay
192.0.0.9
IP-Relay
192.0.0.10
IP-Lan
172.70.207.9
IP-Lan
172.70.207.10
"cnfifip"
37-ATM
37-ATM
"cnfifip"
26-ETHERNET
17941
AXIS1
AXIS2
IP Address
Device Name
172.70.207.6
igx2-lan
192.0.0.6
igx2
192.0.0.7
igx3