Sony 3-875-814-11(1) User Manual

It is necessary to connect the IR Blaster to use 
Quick Click. Connect the IR Blaster according 
to following instructions.

Attach the supplied IR Blaster to components 
connected to the receiver. You can control 
components connected to the receiver via the 
IR Blaster using the on-screen remote control.

After referring to the operating instructions of 
the components connected to the receiver 
make sure to place the IR Blaster just above or 
below the remote sensor. Remote sensors on 
Sony Recorders and other products are 
identified by the 

 symbol.

Do not remove the backing paper from the IR 
Blaster yet.
After configuring the settings, remove the backing 
paper from the IR Blaster and fix it in place.

Place the components and the IR Blaster as 
follows when you want to operate two 
components with the IR Blaster.

If the infrared receivers on the two 
components do not line up as shown in the 
illustration above, you must purchase an 
optional IR Blaster (VM-50, not supplied) and 
install it.

For details on how to set up a component, refer to the 
operating instructions of the component.

If the IR Blaster cable is too short, use a 3.5 mm jack 
extension cable (not supplied).

IR Blaster
(supplied)

Infrared transmitter

Remote sensor

IR Blaster

Remote sensors