Viking 200 User Manual

UL approved
strain relief

Common

Green

Ground

White

Black

Run wires through bottom pan. Using a UL approved

strain relief, connect wires to terminal block.

Green

Ground

Connect ground wire.

NOTE: Reinstall front plate and bottom pan.

Hardwire Conduit Option

Remove any loose items in the dishwasher and carefully lay

the dishwasher on its back. NOTE: Be careful not to pinch

hoses or power cord beneath dishwasher.

Remove bottom pan and front plate. Rapid removal

of the bottom pan will cause damage to the moisture
sensor. To remove the bottom pan for installation and

servicing, slowly pull the bottom pan from the unit

and disconnect the connector wire from the moisture

sensor which is located on the floor of the bottom

pan.

Loosen ground wire and wires on terminal block.

Loosen strain relief and remove cord.

NOTE: Other items are grounded in this location–these

items must remain grounded.

Trim Installation Options

(not available on all units)

To install dishwasher without trim, remove the 6 screws (3 per side) and

remove trim. To attach wiper gasket to dishwasher, pull protective film off
adhesive back on wiper gaskets and apply to leading edge of dishwasher

frame. Trim gasket to fit.