Mr. Coffee DSP10 User Manual

Your Mr. Coffee 

SPEEDBREW ™ coffeemaker comes with a special feature that allows

you to brew a perfect decanter of decaffeinated coffee.  Just turn the brew control dial to
“decaffeinated”.  This feature allows for the additional time needed when brewing decaf-
feinated coffee.  Please note that only decaffeinated coffee should be used when your
brew control dial is in this position.  Caution: To avoid overflowing the brew basket do not
use decaffeinated coffee unless the brew control dial is on the decaffeinated setting.

The same steps listed on page 7 under “Brewing Coffee” can be used to obtain hot water.
Keep the brew basket in place and omit the filter and coffee.  NOTE: This water is hotter
than the water from your faucet and must be handled with care.

The water reservoir in your Mr. Coffee 

SPEEDBREW ™ coffeemaker should be emptied

whenever the coffeemaker will be moved, shipped, or stored.  Please follow these steps:

1.

Turn Reservoir Power Switch OFF, unplug the 

SPEEDBREW ™ power cord and

allow the hot water to cool in the tank.  Place the empty decanter on the warmer 
plate.  Pour a full pitcher of COLD water 
into the water reservoir.  Close the lid and 
wait for the water to stop flowing from the 
brew basket.  Empty the decanter and 
repeat.  This will cool the water in the water
reservoir.

2.

Remove the brew basket.  Grasp the back
of the 

SPEEDBREW™ coffeemaker and

tip the unit forward over a sink as far as
possible. Most of the water in the water 
reservoir will flow from the shower head. 
Continue tipping the coffeemaker until the 
flow of water stops. (see figure 1)

8