Intel Pentium Mobile T2130 LF80539GE0361M Data Sheet

Datasheet

13

In the Sleep state, the processor is incapable of responding to snoop transactions or 

latching interrupt signals. No transitions or assertions of signals (with the exception of 

SLP#, DPSLP# or RESET#) are allowed on the FSB while the processor is in Sleep 

state. Snoop events that occur while in Sleep state or during a transition into or out of 

Sleep state will cause unpredictable behavior. Any transition on an input signal before 

the processor has returned to the Stop-Grant state will result in unpredictable behavior.

If RESET# is driven active while the processor is in the Sleep state, and held active as 

specified in the RESET# pin specification, then the processor will reset itself, ignoring 

the transition through Stop-Grant State. If RESET# is driven active while the processor 

is in the Sleep State, the SLP# and STPCLK# signals should be deasserted immediately 

after RESET# is asserted to ensure the processor correctly executes the Reset 

sequence.

While in the Sleep state, the processor is capable of entering an even lower power 

state, the Deep Sleep state, by asserting the DPSLP# pin. (See 

the processor is in the Sleep state, the SLP# pin must be deasserted if another 

asynchronous FSB event needs to occur. 

Deep Sleep state is a very low power state the processor can enter while maintaining 

context. Deep Sleep state is entered by asserting the DPSLP# pin while in the Sleep 

state. BCLK may be stopped during the Deep Sleep state for additional platform level 

power savings. BCLK stop/restart timings on appropriate chipset based platforms with 

the CK410M clock chip are as follows:

• Deep Sleep entry: the system clock chip may stop/tristate BCLK within 2 BCLKs of 

DPSLP# assertion. It is permissible to leave BCLK running during Deep Sleep.

• Deep Sleep exit: the system clock chip must drive BCLK to differential DC levels 

within 2-3 ns of DPSLP# deassertion and start toggling BCLK within 10 BCLK 

periods.

To re-enter the Sleep state, the DPSLP# pin must be deasserted. BCLK can be re-

started after DPSLP# deassertion as described above. A period of 15 microseconds (to 

allow for PLL stabilization) must occur before the processor can be considered to be in 

the Sleep state. Once in the Sleep state, the SLP# pin must be deasserted to re-enter 

the Stop-Grant state.

While in Deep Sleep state, the processor is incapable of responding to snoop 

transactions or latching interrupt signals. No transitions of signals are allowed on the 

FSB while the processor is in Deep Sleep state. When the processor is in Deep Sleep 

state, it will not respond to interrupts or snoop transactions. Any transition on an input 

signal before the processor has returned to Stop-Grant state will result in unpredictable 

behavior. 

The Intel Pentium Dual-Core processors feature Enhanced Intel SpeedStep Technology. 

Following are the key features of Enhanced Intel SpeedStep technology:

• Multiple voltage/frequency operating points provide optimal performance at the 

lowest power. 

• Voltage/Frequency selection is software controlled by writing to processor MSR’s 

(Model Specific Registers).

— If the target frequency is higher than the current frequency, V

CC

 is ramped up 

in steps by placing new values on the VID pins and the PLL then locks to the 

new frequency.