Panasonic AW-PH405N User Manual

16

 Pan-tilt head mounting conditions

Approx.  lbs 

(10 kg)

Stand-alone 

installation or 

installation on 

the celling

Convertible 

camera series 

AW-E50 
AW-E650 
AW-E655 
AW-E750 
AW-E860

Approx.  

.6 lbs 

(1. kg) 

max.

Wire provided 

used for 

mounting

AW-LZ16MD55P 
AW-LZ16MD7P 

AW-LZ17MD9AG

Approx. .9 lbs 

(1. kg) max.

Approx.  

0.7 lbs  

(0. kg)

Approx.  

8.7 lbs  

(1 kg)

Multi-purpose 

camera series 

AK-HC1500G

Approx.  

. lbs  

(1.5 kg)

HA1 series 
HA series 

HJ17e series 
HJ1e series

Approx. 7.1 lbs 

(. kg) max.

Approx.  

.1 lbs  

(15 kg)

M6 screws (hexagonal nuts)

4 pcs

  Refer to the above table for the total weight of the pan-tilt head with the camera, lens, cables and any 

other accessories installed. 
Install the equipment on an installation surface which is capable of ensuring a drop safety equivalent to 
five times the figure for the total weight.

  The maximum weight of the units which can be installed on the pan-tilt head is .1 lbs (15 kg) or so  

[or approximately 55.1 lbs (5 kg) total for the weight of the pan-tilt head and weight of the units 
installed on the head]. When mounting the pan-tilt head on which units have been installed, be sure to 
mount it on an installation surface which is itself capable of ensuring a satisfactory drop safety.

 Installing the pan-tilt head

Before installing the pan-tilt head, check that the above mounting conditions are satisfied, and observe the following precautions. 
In order to prevent accidents resulting when the product becomes dislodged or falls down, be absolutely sure to proceed as 
instructed. Do not install the pan-tilt head on its side since its prescribed operation and performance cannot be ensured.

 After the pan-tilt head has been installed, mount the camera on it.
 When installing the pan-tilt head, use the four mounting holes to secure the pan-tilt head firmly.
 Ensure that the surface on which the pan-tilt head will be installed and the anchor bolts used are sufficiently strong.
 Use the M6 hexagon head bolts (including one short bolt) for installation.
 Use hexagon head bolts which are longer than the thickness (t) of the mounted member + 1” (5 mm).
 As shown in the figure of next page, use flat washers, spring washers and hexagon nuts for the hexagon head bolts.
 Use a wrench of the appropriate size to tighten up the hexagon head bolts. 
  Provide a wire which is strong enough to support the combined weight of the entire pan-tilt head system (which consists of the 

pan-tilt head, camera, lens and cable).

  Do not use a surface made of plaster board or wood as this kind of installation surface will not be strong enough. If mounting 

on such a surface is unavoidable, take sufficient anti-drop measures.

  Install the pan-tilt head in such a way that the equipment and cable attached to it will not make contact with any surrounding 

objects when the head is swiveled.

 When the unit is no longer going to be used, do not leave it in place, and be absolutely sure to remove it.