Panasonic AW-PH650N User Manual

Page of 44
9
Parts and their functions
Main unit (Pan/tilt head)
 
 
 
    
 
 
 
 Main unit cover
The sunshade cover and main unit cover must be 
removed when the cable compensation circuit or landing 
characteristics are to be changed.
 Grip
Used in carrying, installing, or lifting the pan/tilt head.
 Sunshade cover
This cover protects the pan/tilt head from direct exposure 
to sunlight. 
 Rotary arm
Mount the housing after having installed the housing 
mount frame.
 I/F connector
Connect this to the I/F connector of the camera housing. 
 Anti-fall wire bolt
This bolt fastens the anti-fall wire which prevents the pan/
tilt head from falling from its installed position.
 Pan/tilt head mounting holes (4)
These holes are used to install and secure the pan/tilt 
head.
 Multi connector [MULTI]
The supplied multi cable is connected here.
 Coaxial connector [SDI OUT]
This is used for outputting the SDI or other signals which 
have been input from .
 Option connector [OPTION]
The control signals of the controller’s OPTION button are 
output from this connector. 
Be absolutely sure to use a water-proof cable.
The compatible connector is the R28-P8M4.8 made by 
Tajimi Electronics Co., Ltd.
A filter (supplied) must be 
installed around the cable.
Install it at a distance within 
30 mm from the connector.
Waterproof the filter using 
tape or tube, for instance.
 Power connector [POWER]
The supplied power cable is connected here.
 Grounding bolt
This bolt is used to connect the wire for system grounding 
(frame grounding bolt).
 Coaxial connector [SDI IN]
When an SDI card is installed in the camera, this 
connector is connected to the SDI signal output 
connector.
OPTION
Cable
Filter
Within 30 mm 
from connector
 Service connector
( View of connector as seen 
from the cable)
GND