KUHN RIKON 3020 User Manual

3000STOPR005810R082503

KUHN KNIGHT INC.

1501 West 7th Ave. Brodhead, WI 53520-0167

701 Cherry Ave. Greeley, Co. 80632

ALWAYS STOP MIXER AND DISCONNECT POWER BEFORE SERVICING, REPAIRING, OR CLEANING.

USE SAFE SHOP PROCEDURES AND EXERCISE CAUTION WHEN WORKING ON THIS MIXER!

It is extremely important that the following lubrication guide be followed:

For lubricating bearings, use a good quality multipurpose grease. Replace all damaged or missing grease zerks

immediately. Always clean zerks before using grease gun. Pump the grease in slowly until a slight bead forms

around the bearing seals. Once a month check lines and connections on grease banks for leaks.

Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated under

a no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus minimize

heat-up during operation.

The large drive enclosure is designed to be used as an oil bath; fill front enclosure until the oil level reaches the

plug labeled “oil level ”on the enclosure.

* * * shields removed for illustrative purposes

DESCRIPTION

INPUT SHAFT BEARINGS

AUGER BEARINGS (QTY 4 ALL MODELS)

REEL BEARINGS (QTY 2 ALL MODELS)

JACKSHAFT BEARINGS (

3050,3060,3070,3095

ONLY

)

DOOR GUIDES

DOOR LINKAGES

ROLLER CHAIN TIGHTENER PIVOTS

ROLLER CHAIN (WITH 30WT OIL BATH)

CHECK OIL LEVEL PLUG

ROLLER CHAIN (WITH 30WT OIL BATH)

SCALE CHECK ARMS (

3050,3060,3070,3095 ONLY

)

TOP OF PIN CHECK BEARING (3036,3042 ONLY)

WEIGH BARS (3015, 3020,3025,3030 ONLY)

LUBRICATION FOR OPTIONS

12 VOLT HYDROPACK

LUBRICANT

GREASE

OIL, 30WT

CHANGE OIL, USE

30WT MOTOR OIL

OIL, 30WT

GREASE

DEXTRON ATF

INTERVAL

8-10 HOURS

YEARLY

8-10 HOURS

6 MONTHS

8-10 HOURS

YEARLY

8-10 HOURS

LOCATION

LUBRICATION