Electrolux 9CHG584138 User Manual

62.9680.01_UL

Page 9

•

Before connecting the appliance, flush the water pipes and 
fittings and clean out any dirt.

•

The appliance is designed for connection to fixed lines.

•

Metal installation pipes may not protrude more than 3.9“ 
(10 cm) from the floor or the wall.

•

The maximum water pipe pressure must not exceed 87 psi 
(600 kPa).

•

A mechanical filter, a shutoff valve and a non-return valve 
should be built into the customer fresh water feed pipe. 

•

In general, all national and local water regulations must be 
observed.

•

The appliance is to be connected to the sanitation system 
in accordance with the valid installation connection plans 
and diagrams.

The water connections come up from the floor.

D

Make corresponding openings in the base of the frame to 
lead the hoses through.

D

Remove front panel (B) (see Chapter 3. on page 7).

D

Dismantle the storage space or hot cabinet if necessary.

D

Connect the flexible hoses (5), with a G ½" inside thread, 
with or without fitting a stop valve, to the customer-supplied 
water pipes protruding from the floor.

The water connections come up from the floor or out of the 
wall. For floor connection (see Chapter 6.1.1 on page 9).

D

Pull the flexible hoses (5) out of the open rear wall and con-
nect to the customer-provided water pipes protruding from 
the wall with a G ½" inside thread, with or without fitting a 
stop valve.

D

Position the appliance against the wall.

The appliance outlet pipe must be taken through a sufficiently 
large waste water opening.

Note
Ensure accurate measurement of the waste water collecting 
point and the exact positioning of the appliance.