ADIC 601354 User Manual
Administrative Tasks
3-32
Initial Configuration
601354 Rev A
Create a Drive
After all archives at a site are successfully configured and
registered with VolServ, at least one drive must be defined and
associated with an archive.
registered with VolServ, at least one drive must be defined and
associated with an archive.
The Create Drive command is used to define a drive; four
drive statistics are associated with it. These are the usage count,
current usage time, total usage time, and error count. These
built-in statistics are provided by VolServ software, but only the
usage count is automatically updated by VolServ software.
Usage count indicates the number of times that media are
mounted to a drive.
drive statistics are associated with it. These are the usage count,
current usage time, total usage time, and error count. These
built-in statistics are provided by VolServ software, but only the
usage count is automatically updated by VolServ software.
Usage count indicates the number of times that media are
mounted to a drive.
VolServ clients are responsible for keeping the other three
statistics values updated. It is recommended that they be
defined as follows:
statistics values updated. It is recommended that they be
defined as follows:
•
Current usage time indicates read/write operation time in
seconds since the latest preventive maintenance
seconds since the latest preventive maintenance
•
Total usage time indicates the read/write operation time in
seconds since the drive definition
seconds since the drive definition
•
Error count indicates the number of read/write errors
All statistics are initialized to zero when a drive is defined. Two
of these statistics are cleared when a drive is varied to an
on-line state. Refer to
of these statistics are cleared when a drive is varied to an
on-line state. Refer to
Drive definition is performed via the GUI. Its parameters
consist of the drive ID and media type that the drive supports.
After a drive is defined, it cannot be changed. It must be deleted
and defined again.
consist of the drive ID and media type that the drive supports.
After a drive is defined, it cannot be changed. It must be deleted
and defined again.
Note
VolServ has to be running to define a drive.