Liebherr F1051 User Manual

Page of 18
Problem
Possible Cause
Correction
appliance are
hot*.
The IceMaker
cannot be
switched on.
The  appliance  and  therefore  the
IceMaker are not connected.
u
Connect the appliance (see Start-up).
The IceMaker is
not making ice
cubes.
The IceMaker is not switched on.
u
Switch the IceMaker on.
The  drawer  of  the  IceMaker  is  not
properly closed.
u
Close the drawer properly.
The water connection is not open.
u
Open the water connection.
The  water  supply  to  the  IceMaker
was interrupted.
u
Check  the  connection  to  the  water  supply  (see  the
Assembly  Instructions,  Connecting  the  Water
Supply).
u
Check  the  pipes  and  hoses  (see  the  Assembly
Instructions, Connecting the Water Supply).
There is a blocked filter at the end of
the  water  supply  hose  or  at  the
connecting part on the machine.
u
Clean the filters.
The  waterline  was  not  bled  of  all  air
during installation
u
Please contact your qualified installation plumber to
ensure  the  above  criteria  is  met  before  calling  for
service.
The temperature
is not cold
enough.
The  door  of  the  appliance  is  not
closed properly.
u
Close the appliance door.
Insufficient ventilation.
u
Clear ventilation grilles.
The ambient temperature is too high. u Solution: (see 1.3)
The  appliance  was  opened  too
frequently or for too long.
u
Wait to see whether the required temperature resets
itself  by  itself.  If  not,  contact  the  customer  service
department (see Maintenance).
Too  much  fresh  food  was  placed
inside without SuperFrost.
u
The temperature is incorrectly set.
u
Set to a colder temperature and check after 24 hours
The  appliance  is  too  near  to  a  heat
source (stove, heater etc).
u
Change location of appliance or the heat source.
Display show
two dashes (“-
-”).
The  display  will  only  show  tempera-
tures that are below freezing.
u
When  initially  starting  the  appliance  it  will  not  be
below  freezing.  It  will  take  three  to  five  hours
(depending  on  ambient  conditions)  for  freezing
temperatures  to  be  achieved  and  thus  displayed
numerically.
The  freezer  temperature  has  risen
above  zero  degrees  due  to  a  power
failure or power interruption.
u See also “Power failure” and “ ”
The interior light
is not on.
The appliance is not switched on.
u
Switch on the appliance.
The  door  was  open  for  longer  than
15 minutes.
u
The  interior  light  automatically  switches  itself  off  if
the door has been open for about 15 minutes.
Troubleshooting
* Depending on model and options
15