Yamaha 006IPTO-F0 User Manual

Setting the Stereo Out and Bus Out 1–8 from the Display

Bus Outs

To set the Stereo Out and Bus Out 1–8 parameters, you can either move the cursor to the 
desired parameter on the display and change the value, or operate the desired button or 
control on the top panel.

This section explains how to set the parameters on the display.

To attenuate the Stereo Out and Bus Out signals, press the SELECTED CHANNEL EQUAL-
IZER [DISPLAY] button repeatedly to display the EQ | Out Att page. On this page, you can 
attenuate the Bus Out 1–8, Aux Out 1–8, and Stereo Out signals.

The parameters on this page (and the procedure for setting them) are the same as for Input 
Channels, except that this page does not include the bit shift parameters (see page 67).

To delay the Stereo Out and Bus Out 1–8 signals, press the [

/INSERT/DELAY] button 

repeatedly until the 

/INS/DLY | Out Dly page appears.

The parameters on this page (and the procedure for setting them) are the same as for Input 
Channels, except that this page does not include the MIX/FB.GAIN parameters (see 
page 63).

Tip:  Refer to Chapter 9 “Input & Output Patching” on page 109 for more information on 
how to set inserts.