Panasonic NC-HU301P User Manual

Page of 52
23
Mesh filter
 
If the problem cannot be resolved, or if you think something is still wrong with the unit, disconnect 
the plug, reconnect after 30 seconds and operate it again.
 
Inside lid may turn yellow, but operation will not be affected.
 
“Clickety-clack” sound caused when open and close the lid is the sound caused by the valve 
swing to prevent the hot water run off.
 
Outside body becomes 113°F(45°C) while warm keep if the room temperature is high.
The unit doesn’t 
turn on .
 If the electric components 
get wet, the unit must 
be repaired. Contact the 
store where you purchased 
the unit for repair.
 You poured in water directly from a tap.
 You put the unit on the sink.
 You turned the unit upside down with 
  its bottom wet.
 You washed the unit in water.
Replacement of Parts
Replacement of Parts
Replace gaskets if they crack, lose their pliancy 
or, for any other reasons which allow steam to 
escape from between the container and the lid.
Replace the filter if foreign materials which 
clog the filter cannot be removed even after 
you scrub with a cleaning brush, etc.
Lid cover
Set gaskets
Consumable parts are available from an 
authorized dealer.
Part name 
Part No. 
Rubber gasket set 
APH65-613-0S 
Mesh filter 
APB97-480-0U 
Remove lid, unscrew 3 tapping screws and 
remove the lid cover.
Exchange the gaskets and then place the lid 
cover back and secure with the tapping screws.
The indicator lights flash
alternately and displays 
.
 This is a malfunction of the sensor. Contact the retailer where you 
purchased the unit.
Rubber gasket set
NC-HU401_301-EN-6.indd   23
11/12/08   2:35:59 PM