Blodgett KTG-E User Manual

5

Immediately after unpacking, check for possible shipping damage.  If the kettle is found to
be damaged, save the packaging materials and contact the carrier within 15 days of
delivery.

1.  The kettle must be installed in accordance with:

2.  State and/or local codes.

3.  In the USA, the National Electrical Code, ANSI/NFPA-70 (latest edition).  In Canada,

the Canadian Electrical Code, Part 1, CSA Standard C22.1 (latest edition).

4.  Position appliance on counter allowing sufficient rear clearance from wall to tilt freely

and completely without obstruction.

5.  Mark four corner locations of appliance base.

6.  Remove appliance from counter and locate position of 4 holes as per Figure 1.  Drill

four 7/16" diameter holes.

7.  Use 5/16-18 Hex Cap Screws with suitable flat washers to bolt down.  Screw length

must be 1-1/4 long plus counter top thickness.

8.  Apply a continuous bead of Silastic or other equivalent sealant along the complete

perimeter edge of the appliance base.

9.  Wipe off excess sealant.

10. A Control Box with power supply equivalent to Electrical Rating of appliance should be

located conveniently nearby.