Sharp AX-1100J User Manual
4
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, and the feature sticker from the outside of the door, if
there is one. Check the unit for any damage, such as a misaligned door, damaged door seals around the
door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven
until it has been checked by a service centre approved by SHARP and repaired, if necessary.
door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven
until it has been checked by a service centre approved by SHARP and repaired, if necessary.
2. Accessories provided
1) Rack 2) Glass tray 3) Steam tray 4) Combined operation manual and cookbook 5) Touch guide
3. Since the door may become hot during cooking, and in order to avoid its accidental touch, the oven should
be placed at least 85 cm or more above fl oor. You should also keep children away from the door to prevent
them burning themselves.
them burning themselves.
4. This oven is designed to be used on a countertop or in a cabinet. It should not be installed in any area
where excessive heat and steam are generated, for example, next to a conventional oven unit. It should
not be installed near combustible materials, for example, curtains. The oven should be installed so as not
to block ventilation openings. Allow a space of at least 15cm on the top, 10cm on both sides and at the rear
of the oven for adequate air circulation. When installing in a cabinet, the minimum inside dimension of the
cabinet should be 720mm(W) x 480mm(H) x 600mm(D). Refer to Figure 1 below. This oven is not designed
for built-in installation.
not be installed near combustible materials, for example, curtains. The oven should be installed so as not
to block ventilation openings. Allow a space of at least 15cm on the top, 10cm on both sides and at the rear
of the oven for adequate air circulation. When installing in a cabinet, the minimum inside dimension of the
cabinet should be 720mm(W) x 480mm(H) x 600mm(D). Refer to Figure 1 below. This oven is not designed
for built-in installation.
5. Do not connect other appliances to the same socket using an adaptor plug.
6. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
6. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure. The A.C. voltage and frequency
must be single phase 230-240V, 50Hz.
must be single phase 230-240V, 50Hz.
7. This appliance must be earthed.
8. Operate the oven from a general purpose domestic outlet. If a generator is used, do not operate the oven
8. Operate the oven from a general purpose domestic outlet. If a generator is used, do not operate the oven
with non-sinusoidal outputs.
Figure 1
15cm
10cm
10cm
10cm
480mm
600mm
720mm
SCA AX1100J.indd Sec1:4
SCA AX1100J.indd Sec1:4
10.12.24 10:24:06 AM
10.12.24 10:24:06 AM