GE JTP20 User Manual
1
30” Built-In Wall Oven
Installation
Instructions
Instructions
JTP20, JTP25, JTP28, JTP48, JTP50, JT912,
JT915, JT952, JT955, ZET938, ZET958
JT915, JT952, JT955, ZET938, ZET958
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
ge.com
Before You Begin
Read these instructions carefully and completely.
•
IMPORTANT
—Save these
instructions for local inspector’s use.
•
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
•
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Tools Needed
1/8” Drill Bit and
Electric or Hand Drill
Electric or Hand Drill
Phillips
Screwdriver
Screwdriver
Materials Needed
Strain Relief Clamp
for 1/2” conduit
for 1/2” conduit
Junction
Box
Box
Wire Nuts
36” of String
31-10659
1-07 JR
Parts Included
Screws For
Installation
Installation
Metal
Bottom Trim
Bottom Trim
Plastic
Bottom Trim
Bottom Trim
Optional
Metal Bottom
Trim Assembly
(on some models)
Metal Bottom
Trim Assembly
(on some models)