Hoshizaki KM-1800SAH/3 User Manual

13

1. 

Remove all shipping cartons, tape and packing. If packing material is left in 

the icemaker, it will not work properly.

. Ensure all components, fasteners and thumbscrews are securely in place.

• Remove the panels to prevent damage when installing the icemaker. (See "B. How to 

Remove Panels.")

• Remove the package containing the accessories from the compressor compartment.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the 

sun or to heat, remove the film after the icemaker cools.

• Check that the refrigerant lines do not rub or touch lines or other surfaces.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied 

corresponds with the voltage specified on the nameplate.

• This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE 

STORAGE BIN, Model B-800 series.

• Front Panel: Remove the two screws. Lift up and pull 

towards you.

• Top Panel: Remove the two screws, and then lift off.
• Side Panel (R): Remove the screw. Pull slightly 

towards you, and take off.

• Insulation Panel: Remove the thumbscrew. Lift up 

slightly, and pull towards you.