Hoshizaki KM-320MAH-E User Manual

2

7. This icemaker will not work at subfreezing 

temperatures. To prevent damage to the 
water supply line, drain the icemaker when 
air temperature is below zero. 

This icemaker requires an earth that meets the 
national and local electrical code requirements. 
To prevent possible severe electrical shock to 
individuals or extensive damage to equipment, 
install a proper earth wire to the icemaker. Turn 
off the power supply before any maintenance, 
repairs or cleaning is undertaken.

• This icemaker must have a separate power supply 

or receptacle of proper capacity. See the nameplate. 
It is recommended that this icemaker be the only 
electrical device on its power supply circuit. 

• Stacked icemakers should each have a separate 

receptacle.

• Usually an electrical permit and services of a licensed 

electrician are required.

• If a power cord and/or a plug should need to be fitted/

replaced, it should only be done by a qualified service 
engineer.

• Factory fitted power cords are coloured in accordance 

with the following code:

Green & Yellow = Earth
Blue = Neutral
Brown = Live

(Plugs and power cords are not supplied with the 
KM-1301SAH-E.)

For the U.K. and the Republic of Ireland Only
• The non-rewirable plug must never be used without a 

fuse cover being fitted.

• The correct replacement for the detachable fuse 

cover is identifiable from the manufacturer’s reference 
number stamped on the plug.

• Supply of replacement fuse covers can be obtained 

from Hoshizaki Parts/Service Centres.

• Fuses should be rated at 13A and approved to 

BS 1362.

A suitably sized power supply cord (see the rating on 
the nameplate) must be fitted by a qualified installer 
into the terminal box on the rear of the machine. The 
wires in the terminal box are coloured in accordance 
with the following code:

Green & Yellow = Earth
Blue = Neutral
Brown = Live

1. This booklet is an integral and essential 

part of the product and should be kept and 
preserved by the user. Please read carefully 
the guidelines and warnings contained herein 
as they are intended to provide the user 
with essential information for the continued 
safe use and maintenance of the product. In 
addition, it provides GUIDANCE ONLY to the 
user on the correct services and site location 
of the icemaker. Please preserve this booklet 
for any further consultation that may be 
necessary.

2. This is a commercial icemaker, and should 

be destined only to be used for the purpose 
for which it has been expressly designed 
and attached to a suitable storage bin as 
specified by Hoshizaki. Any other use should 
be considered improper and therefore 
dangerous. The manufacturer will not be held 
liable or responsible for any damage caused 
by improper, incorrect and unreasonable use.

The installation must be carried out by 
qualified personnel, in accordance with current 
regulations, according to the manufacturer’s 
instructions.

1. This icemaker is not intended for outdoor 

use. Normal operating ambient temperature 
should be within +7°C to +40°C. Normal 
operating water temperature should be within 
+7°C to +35°C. Operation of the icemaker, 
for extended periods, outside of these normal 
temperature ranges may affect production 
capacity.

2. The icemaker should not be located next to 

ovens, grills or other high heat producing 
equipment. 

3. The location should provide a firm and level 

foundation for the equipment.

4. Allow 15 cm. clearance at rear, sides and 

top for proper air circulation and ease of 
maintenance and/or service should they be 
required.

5. This appliance is not suitable for installation 

in an area where a water jet could be used 
and where dripping is not allowed.

6. Do not place anything in front of the louver.