Hoshizaki C-100BAF User Manual

26

1. All parts are factory-adjusted. Improper adjustments may adversely affect 

safety, performance, component life, and warranty coverage.

2. If the icemaker is turned off, wait for at least 3 minutes before restarting the 

icemaker to prevent damage to the compressor.

3. At startup, confirm that all internal and external connections are free of leaks.

1) Open the water supply line shut-off valve.
2) Make sure the power switch is in the "OFF" position. Plug the unit into the electrical

outlet. If you have to slide the unit back for a built-in installation, make sure you do not 
damage or pinch the water supply, drain connections, or power cord.

3) If required by sanitation code in your area, seal the perimeter where the machine 

touches the floor with approved caulk compound in a smooth and easily cleanable 
manner.

4) Move the power switch to the "ON" position to start the automatic icemaking process.
5) Once the unit starts to produce ice, allow it to run for another 30 minutes.
6) Move the power switch to the "OFF" position.
7) Remove the ice produced, then clean the storage bin liner, door liner, and door gasket 

using a neutral cleaner. Rinse thoroughly after cleaning.

8) Move the power switch to the "ON" position to start the automatic icemaking process.
9) To confirm bin control operation, hold ice in contact with the bin control thermostat bulb. 

The icemaker should stop within 10 seconds. 

• Wash your hands before removing ice. Use the plastic scoop provided.
• The storage bin is for ice use only. Do not store anything else in the storage bin.
• If ice is not used on a regular basis, it may bond together in the storage bin. In this

case, discard the bonded ice and allow the icemaker to make fresh ice.