Tektronix AWG710B User Manual

The Pattern Editor

AWG710&AWG710B Arbitrary Waveform Generator User Manual

Follow the steps below to execute code conversion:

1. Push the Save... side button and name the file.

2. Push OK side button.

Code conversion is executed with the specified pattern as the source code. The 
result of code conversion is displayed in a new window.

You can use the Zoom function to expand or shrink the waveform display in an 
editor window. The Pan function lets you scroll the pattern image to show 
waveform data that lies outside the edit display.

The Zoom/Pan menu commands are the same as those for the Graphical Waveform 
editor except that you cannot select vertical zoom/pan operations. You can only 
zoom or pan horizontally in the Pattern Editor. Refer to The Zoom/Pan Menu

 

section on page 3-81 for a description of the vertical Zoom and Pan menu 
commands.

The Window menu displays a side menu that lets you select which edit window is 
active. Push the side button of the window you want to make active.

The Settings menu commands define editor setup parameters, including waveform 
record length, clock frequency, display mode, cursor linking, grid on/off, and so 
on.

 

The Settings menu commands are the same as those for the Graphical 

Waveform editor except for Grid and Interpolation. You can set grid and/or 
interpolation. However, the pattern editor does not use these parameters. These 
parameters are used only for the waveform editor when you are editing two or more 
windows. Refer to The Settings Menu

 

section on page 3-82 for a description of the 

Settings menu commands.

The Undo! command reverses the last edit operation. This is only a one–level undo 
function.