Tektronix AWG710B User Manual
Appendix A: Specifications (AWG710)
A-40
AWG710&AWG710B Arbitrary Waveform Generator User Manual
Certification and Compliances
The certification and compliances for the AWG710 Arbitrary Waveform Generator
are listed in Table A-50.
are listed in Table A-50.
Table A-50: Certifications and compliances
Characteristics
Description
EC declaration of conformity
EC council EMC Directive 89/336/EEC, amended by 89/336/EEC; EN61326-1: 1997 Product
Family Standard for Electrical Equipment for Measurement, Control, and Laboratory
Use-EMC Requirements.
Family Standard for Electrical Equipment for Measurement, Control, and Laboratory
Use-EMC Requirements.
Emissions:
EN 55011 Class A
EN 61000–3–2
EN 61000–3–2
Radiated and Conducted emissions
Power Line Harmonic
Power Line Harmonic
Immunity:
EN 61000–4–2
EN 61000–4–3
EN 61000–4–4
EN 61000–4–3
EN 61000–4–4
6
EN 61000–4–5
EN 61000–4–6
EN 61000–4–11
EN 61000–4–6
EN 61000–4–11
Electrostatic Discharge Immunity
Radiated RF Electromagnetic Field Immunity
Electrical Fast Transient/Burst Immunity
Surge Immunity
Conducted Disturbances Induced by RF Field Immunity
Power Line Interruption Immunity
Radiated RF Electromagnetic Field Immunity
Electrical Fast Transient/Burst Immunity
Surge Immunity
Conducted Disturbances Induced by RF Field Immunity
Power Line Interruption Immunity
Compliance was demonstrated to the following specification as listed in the Official Journal of
the European Communities:
the European Communities:
Low Voltage Directive 73/23/EEC, amended by 93/68/EEC
EN 61010–1/A2:1995
Safety requirements for electrical equipment for measurement,
control, and laboratory use
control, and laboratory use
Australia/New Zealand declaration of
conformity - EMC
conformity - EMC
Conforms with the following standards in accordance with the Electromagnetic Compatibility
Framework:
Framework:
AS/NZS 2064.1/2
Class A radiated and Conducted Emissions
Safety
UL3111–1 - Standard for electrical measuring and test equipment
Third party certification
CAN/CSA C22.2 No. 1010.1 - Safety requirements for electrical equipment for measurement,
control and laboratory use
control and laboratory use
Self declaration
IEC 61010–1/A2:1995 - Safety requirements for electrical equipment for measurement,
control, and laboratory use
control, and laboratory use
Installation category
Power input — Installation Category II (as defined in IEC 61010–1, Annex J)
Pollution degree
Pollution Degree 2 (as defined in IEC 61010–1)
6
Up to 200 mV
p–p
noise is allowed on the output during this test.