Emerson I-0021 User Manual
5 - 84
NGA 2000
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
Main Menu — Analyzer and I/O-module expert configuration
↓↓
I/O module controls
↓↓
SIO module
↓↓
From the menu "SIO - Configuration Parameters" you can change to submenus to control
and set up several output configurations of the auxiliary SIO module.
General Configuration of a SIO board (for the whole specification see its own manual):
and set up several output configurations of the auxiliary SIO module.
General Configuration of a SIO board (for the whole specification see its own manual):
♦
Analog outputs: minimum 2, maximum 8
♦
Serial interface (RS 232 or RS 485) to connect the analyzer with an external computer
♦
Three relay outputs
If there is a SIO module installed in the platform or in the MLT analyzer, you have to put in
"Yes" in the line "Module installed", otherwise "No".
"Yes" in the line "Module installed", otherwise "No".
Set up parameters:
♦
Select the line of variables or any menu line with the
↓↓
-key or the
↑↑
-key.
♦
Select the variable or change to the submenu with the
88
-key or the
→
→
-key.
♦
Select the parameter with the
↑↑
-key or the
↓↓
-key.
♦
Confirm the new adjustment with the
88
-key or
cancel and go back to the last value with the F2 key.
Measure
TAG
F1
F2
F3
F4
F5
95.00 ppm
-- SIO-Configuration Parameters --
Analog output setup...
Serial interface setup...
Configuration of Relay Outputs...
Module installed:
Yes
Back...
5.2 I/O Module Controls
5.2.1 SIO Module