Motorola 700/800-Series User Manual

A-6

Configure and Environment Commands

Network Auto Boot Enable 
[Y/N]

N

Network Auto Boot function is disabled. 

Network Auto Boot at power-
up only [Y/N]

Y

Network Auto Boot is attempted at 
power up reset only. 

Network Auto Boot 
Controller LUN

00

LUN of a disk/tape controller module 
currently supported by the Bug. Default 
is $0. 

Network Auto Boot Device 
LUN

00

LUN of a disk/tape device currently 
supported by the Bug. Default is $0. 

Network Auto Boot Abort 
Delay

5

The time in seconds that the Network 
Boot sequence will delay before starting 
the boot. The purpose for the delay is to 
allow you the option of stopping the boot 
by use of the Break key. The time value is 
from 0 through 255 seconds. 

Network Autoboot 
ConÞguration Parameters 
Pointer (NVRAM)

00000000

The address where the network interface 
conÞguration parameters are to be 
saved/retained in NVRAM; these 
parameters are the necessary parameters 
to perform an unattended network boot.

Memory Search Starting 
Address

00000000

Where the Bug begins to search for a 
work page (a 64KB block of memory) to 
use for vector table, stack, and variables. 
This must be a multiple of the debugger 
work page, modulo $10000 (64KB). In a 
multi-162 environment, each 
MVME162LX board could be set to start 
its work page at a unique address to 
allow multiple debuggers to operate 
simultaneously.