Motorola 700/800-Series User Manual

Solving Startup Problems

D-3

IV. Continued

2. At the command line prompt, type in:

 <CR>

This sets up the default parameters for the debugger 
environment.

3. When prompted to Update Non-Volatile RAM, type in:

4. When prompted to Reset Local System, type in:

5. After clock speed is displayed, immediately (within Þve 

seconds) press the Return key:
<CR>
or
BREAK
to exit to the System Menu. Then enter a 3 for ÒGo to 
System DebuggerÓ and Return:
3 <CR>
Now the prompt should be:

162-Diag>

6. You may need to use the cnfg command (see your board 

Debugger Manual) to change clock speed and/or Ethernet 
Address, and then later return to:
env <CR>
and step 3.

7. Run the selftests by typing in:

st <CR>
The tests take as much as 10 minutes, depending on RAM 
size. They are complete when the prompt returns. (The 
onboard selftest is a valuable tool in isolating defects.)

8. The system may indicate that it has passed all the selftests. 

Or, it may indicate a test that failed. If neither happens, 
enter:
de <CR>
Any errors should now be displayed. If there are any 
errors, go to step VI. If there are no errors, go to step V.