TEAC E24E User Manual
For Windows 98SE/Me/2000
28
TEAC PortaCD-RW User’s Manual
Installing the PortaCD-RW Driver Using the Windows Wizard
This section explains how to install the PCMCIA driver using the Windows
Add
New Hardware
Wizard.
For Windows 98SE/Me/2000
The installation procedure for the PCMCIA Card Driver varies depending on the
version of Windows 98SE/Me/2000 installed in your computer.
version of Windows 98SE/Me/2000 installed in your computer.
To install the driver on a Windows 98SE/Me/2000 system, follow these steps:
1.
Insert the PCMCIA card into the PCMCIA card slot in your laptop
computer.
computer.
The other end of the card/cable should already be connected to the interface
connector on the PortaCD-RW. (If not, see “Chapter 3. Connecting the
PCMCIA PortaCD-RW to a Windows System” on page 23 for more
information.)
connector on the PortaCD-RW. (If not, see “Chapter 3. Connecting the
PCMCIA PortaCD-RW to a Windows System” on page 23 for more
information.)
The system displays the initial
Add New Hardware Wizard
Figure 30. Add New Hardware Wizard
2.
Click the
Next
button to search for the driver.
The system displays the following
Add New Hardware Wizard
panel
Note: The system configuration and your dialog responses determine which panels
the Wizard will display. Do not be concerned if your installation process varies
slightly from the one described below—just follow the dialog instructions.
the Wizard will display. Do not be concerned if your installation process varies
slightly from the one described below—just follow the dialog instructions.
PortaCDRW.book Page 28 Wednesday, April 4, 2001 10:49 PM