Aleratec 260203 User Manual

www.aleratec.com

33

You can select “No Counter” if you prefer to copy continuously with no 

interruption. (It will still count the number of copies, but it will not notify 

you when to stop.) To select the “No Counter”, simply press ENT button 

when you see the screen above. Then skip below and continue on to step 

“d”.
Or, you can select “Specify Counter” to specify the number of copies (1 to 

9999) by pressing the UP or DOWN navigation button to the below screen:

Then please press ENT button to submit. You will see the screen below:

To specify the number of copies for your project, you need to enter/input 

a 4-digit number. If you are planning to specify a number that is less than 

4 digits, please fill the leading spaces with “0”s (any leading “0” will 

be skipped). An example of that 4-digit number could be “0234” (Two 

hundred and thirty four), or “0010” (ten). Remember, the beginning “0”s 

are skipped, therefore “0010” means “10”, which is the number 10.

To enter the number, you need to use UP or DOWN button to select the 

number for each digit and use ENT or ESC button to move the cursor 

position right or left, once you’ve finished, move the cursor to OK and 

press ENT. For example, if I want to specify a counter value of 21 (twenty 

one). The 4-digit value would be “0021”. To input the desired quantity, 

please do the following:

Make sure the cursor is located at the first position:

i.  Press DOWN button consecutively until “0” is displayed.
ii.  Press ENT button once to move the cursor to the next position.
iii.  Press DOWN button consecutively until “0” is displayed.
iv.  Press ENT button once to move the cursor to the next position.
v.  Press DOWN button consecutively until “2” is displayed.
vi.  Press ENT button once to move the cursor to the next position.











