Aleratec 260203 User Manual

www.aleratec.com

55

Disadvantage:

 ▪ The loading time may have an impact on overall duplication time for small 

duplication jobs.

 ▪ The Master Disc will be loaded to the reserve partition in the Hard Drive 

temporarily until a new master is loaded and overrides the previous image. 

In comparing this duplication mode with the traditional “Duplication from 

Hard Drive” process, it offers the user more simplicity. By selecting the 

“Load and Copy” mode via one simple touch, all the necessary tasks will 

be automated for you and loaded on to the “Reserved” partition. You can 

rename the data on the “Reserved” partition and place it in a standard 

partition if you wish to keep it. (This must be done prior to loading a new 

master through “Load and Copy)”.

By default, the duplication mode is set to “Auto”. This will prompt you to choose 

between one of the duplication modes when you enter any of the following 

functions: “Copy”, “Test”, “Test + Copy”, and “Copy + Compare”.
However, if you prefer not to be prompted each time, you can always go to “14. 

Setup” and select sub-menu 9 and manually reset it. To do so, preform the following 

steps:

1.  Turn on the duplicator. After the bootup is complete, you will see the following 

display:

2.  Press the UP or DOWN button consecutively until you see following display:

3.  Press ENT button once. You will see the following display:

4.  Press the UP or DOWN button consecutively until you see following display:















