Intel CM8063501287403 User Manual

 

88

Intel® Xeon® Processor E5-1600 v2/E5-2600 v2 Product Families 

Datasheet Volume One of Two

While executing code, Enhanced Intel SpeedStep® Technology optimizes the 
processor’s frequency and core voltage based on workload. Each frequency and voltage 

operating point is defined by ACPI as a P-state. When the processor is not executing 
code, it is idle. A low-power idle state is defined by ACPI as a C-state. In general, lower 

power C-states have longer entry and exit latencies.

The following are the key features of Enhanced Intel SpeedStep® Technology:

• Multiple frequency and voltage points for optimal performance and power 

efficiency. These operating points are known as P-states.

• Frequency selection is software controlled by writing to processor MSRs. The 

voltage is optimized based on temperature, leakage, power delivery loadline and 
dynamic capacitance.

— If the target frequency is higher than the current frequency, V

CC

 is ramped up 

to an optimized voltage. This voltage is signaled by the SVID Bus to the voltage 

regulator. Once the voltage is established, the PLL locks on to the target 

frequency.

— If the target frequency is lower than the current frequency, the PLL locks to the 

target frequency, then transitions to a lower voltage by signaling the target 

voltage on the SVID Bus.

— All active processor cores share the same frequency and voltage. In a multi-

core processor, the highest frequency P-state requested amongst all active 

cores is selected.

— Software-requested transitions are accepted at any time. The processor has a 

new capability from the previous processor generation, it can preempt the 

previous transition and complete the new request without waiting for this 

request to complete.

• The processor controls voltage ramp rates internally to ensure glitch-free 

transitions.

• Because there is low transition latency between P-states, a significant number of 

transitions per second are possible.

When the processor is idle, low-power idle states (C-states) are used to save power. 

More power savings actions are taken for numerically higher C-states. However, higher 

C-states have longer exit and entry latencies. Resolution of C-states occurs at the 
thread, processor core, and processor package level. Thread level C-states are 

available if Intel Hyper-Threading Technology is enabled. Entry and exit of the C-States 

at the thread and core level are shown in