Haier WDNS116BBS User Manual

Page of 28
4
English
1.  Remove all packing materials. This includes the foam base and all adhesive 
tape holding the accessories inside and outside.
2.  Inspect and remove any remaining packaging, tape and printed material 
before turning on the water dispenser. 
Note:  Allow the water dispenser to stand in an upright position for at least 
12 hours before turning on the power.
PROPER LOCATION
•  To ensure that your water dispenser works at the maximum efficiency it was 
designed for, you should install it in a location where there is proper air 
circulation and electrical connections.
•  The following are the recommended clearances around the water dispenser.  
  
Sides 
2" (50mm) 
  
Back 
4" (100mm)
•  Do not install your water dispenser in any location that is not properly 
insulated or heated because the unit is not designed to operate in room 
temperature below 55˚F / 13˚C. The water dispenser is for indoor use only. 
Room temperature should not exceed 97° F / 36° C. 
Note:  Thermostats maintain the hot and cold water temperatures 
automatically. On the compressor cooled water coolers the hot water 
temperature will be between 190˚-203˚ F/ 88˚- 95˚ C and the cold 
water temperature will be between 43˚- 50˚ F/ 6˚-10˚ C.
•  Select a suitable location for the unit on a hard even surface away from 
direct sunlight and heat sources (e.g., radiators, baseboard heaters, cooking 
appliances, etc.).  
CAUTION:  DO NOT plug in the water dispenser until full bottle is 
installed first and water flows from both Hot and Cold 
water faucets.
  Note:  Hot and cold water will not be instantly available as the unit will need 
time to heat up and cool down the water.
PREPARATION BEFORE FIRST OPERATION
Before connecting the unit to the power source, Let it stand upright for 
approximately 12 hours. This will reduce the possibility of a malfunction in the 
cooling system from handling during transportation.
The water dispenser is pre-cleaned at the factory but the reservoir and water 
lines should be flushed with fresh water before use as follows:
1. Do NOT plug in the water dispenser.
2.  Check and make sure the drain cap on the back of the water dispenser is 
firmly closed.
 INSTALLATION INSTRUCTIONS