Sony 2 User Manual

325

Macro Attachment Assigning

  Chapt

er

 1

8

 

Mac

ros

To execute a macro by means of the macro attachment set for a button in the 
cross-point control block of an M/E bank or the PGM/PST bank, use the 
following procedure.

In the cross-point control block, press the [MCRO ATTCH ENBL] button, 
turning it on.

Press the desired button for which a macro attachment has been set.

This recalls the macro register assigned to the button, and the macro is 
executed as follows, according to the operation mode.
Pre macro mode: The macro is executed first, and then the button 

function is executed.

Post macro mode: The button function is executed first, and then the 

macro is executed.

Macro only mode: The button function is not executed, and the macro 

only is executed.

During macro execution, the button you pressed flashes.

• It is not possible to execute more than one macro at a time. Therefore, even 

if you simultaneously press multiple buttons for which macro attachments 
are set, only one macro is executed.

• During macro execution, recalling the same register again stops the macro 

being executed. Therefore, pressing twice a button for which a macro 
attachment is set stops the macro being executed.

• Individual events stored in a macro are executed according to the settings in 

setup. If you change the settings in setup, a saved macro may not have the 
expected effect.

• During macro execution, if you switch the control panel to macro editing 

mode, the macro being executed stops.

• During macro editing, pressing a button for which a macro attachment is set 

does not execute the macro.

In the cross-point control block of the M/E or PGM/PST bank for which you 
want to disable the settings, press the [MCRO ATTCH ENBL] button, turning 
it off.
In this state, pressing a button for which a macro attachment is set does not 
execute the macro.