Adaptec ACS-100 User Manual
7
Installing a Disk Drive
Before you begin, ensure that you are installing the proper disk
drive. The Adaptec ACS-100 USB Enclosure supports 3.5-inch IDE
hard disk drives only.
drive. The Adaptec ACS-100 USB Enclosure supports 3.5-inch IDE
hard disk drives only.
Note:
You need a Phillips screwdriver to complete this task.
To install a disk drive into your USB Enclosure:
1
Use a screwdriver to remove the two screws on the back of the
enclosure.
enclosure.
2
Remove the enclosure’s back panel, as shown below, and slide
out the disk drive tray.
out the disk drive tray.
3
Connect the disk drive tray’s internal power connector and IDE
cable to the disk drive.
cable to the disk drive.