Sharp SJ-244V User Manual

Page of 8
3
WARNING  
CAUTION  
INSTALLATION  
 1. 
 2. 
Using the front Adjustable foot, ensure that the 
refrigerator is positioned firmly and level on the floor.
 3. 
Connect the power plug to a 230/240 volt. 10 amp.
power point.
Before using your refrigerator 
Clean the inside parts with a cloth soaked in warm water. 
If soapy water is used, wipe it off thoroughly with water.
Adjustable 
foot 
Dust deposited on the power plug may cause fire. Wipe 
it off carefully.
Do not attempt to change or modify this refrigerator. This 
may result in fire, electric shock or injury. 
Ensure that the refrigerator presents no danger to 
children while being stored for disposal. (e.g. remove the 
door to prevent child entrapment.) 
Do not touch the compressor unit or its peripheral parts, 
as they become extremely hot during operation and the 
metal edges may cause injury.
Do not touch foods or metal containers in the freezer 
compartment with your wet hands. This may cause 
frostbite.
Do not place bottled and canned drinks in the freezer as 
they may crack when frozen.
In case of gas leak, ventilate the area by opening a 
window, etc. Do not touch the refrigerator or the power 
outlet.
Do not place objects containing liquid or unsteady 
objects on top of refrigerator.  
This refrigerator is not intended for use by persons 
(including children) with reduced physical, sensory or 
mental capabilities, or lack of experience and 
knowledge, unless they have been given supervision or 
instruction concerning use of the refrigerator by a person 
responsible for their safety. Young children should be 
supervised to ensure that they do not play with the 
refrigerator.
WARNING
Do not install the refrigerator in a damp or wet      
location as this may cause damage to the 
insulation and a leak. Condensation may also 
build on the outer cabinet and cause rust. 
1. 
3. 
2. 
4. 
5. 
2. 
3. 
4. 
5. 
6. 
7. 
SJ-244V
970mm
1145mm
1065mm
1221mm
a
b
60mm
90mm
60mm
60mm
Keep adequate ventilation space around the 
refrigerator.
The figure shows the minimum required space for 
installing the refrigerator. It differs from the space in 
the measurement condition of the amount of power 
consumption.
SJ-308V
SJ-339V
NOTE :
• 
• 
Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
Attention about Power supply:
Do not use an extension cord or adapter plug.
Make sure that the power cord has not been damaged 
during installation or moving. If the power plug or cord 
is loose, do not insert the power plug. There is a risk 
of electric shock or fire.
Disconnect from the mains electricity supply by 
removing the mains plug from the electricity supply 
socket. Do not remove by pulling the mains lead. This 
may cause electric shock or fire.
Should the flexible supply cord be damaged, it must 
be replaced by service agent approved by SHARP as 
a special cord is required.
1.
• 
• 
• 
• 
Insufficient spacing will decrease cooling efficiency 
and increase energy consumption.
This may reduce the life of the unit and void warranty.
This refrigerator is designed for indoor use only, do not 
place the unit on an unsealed surface.
 
 
 
 
 
 
 
 
Do not store highly volatile and flammable materials such 
as ether, petrol, propane gas, aerosol cans, adhesive 
agents and pure alcohol etc.
These materials are liable to explode.
This refrigerator contains flammable refrigerant (R600a: 
 
isobutane) and insulation blowing gas (cyclopentane). 
Observe the following rules to prevent ignition and explosion.
The refrigeration system behind and inside the refrigerator 
• 
contains refrigerant. Do not allow any sharp objects to 
come into contact with the refrigeration system.
Do not use mechanical devices or other means to 
• 
accelerate the defrosting process. (This refrigerator has 
adopted automatic defrosting system.)
Do not use electric appliances inside the refrigerator.
• 
Use only the specified parts for the refrigerator 
• 
compartment light.
Do not block the openings on the circumference of the 
• 
refrigerator.
Do not use flammable sprays, such as spray paint near 
• 
the refrigerator. It may cause explosion or fire.
If the refrigeration system should get punctured, do not 
• 
touch the wall outlet and do not use open flames. Open 
the window and air out the room. Then ask a service 
agent approved by SHARP for servicing.
This refrigerator should be disposed appropriately. 
• 
Take the refrigerator to a recycling plant for flammable 
refrigerant and insulation blowing gases.